Tyre Fitting at our own workshop on London Road, Hackbridge SM6. Put your registration in and we will have the right sizes on the shelf before you arrive rather than ordering them while you wait.
Sutton Council’s own ward parking survey for Wandle ward, which covers Hackbridge, found 67 per cent of residents reporting a
parking problem on their street, 39 per cent parking on the road and nearly nine in ten households
with at least one car. The Edwardian streets off London Road were laid out before any of that,
and the result is parking spaces that are exactly as long as a car and no longer.
Tyres and wheels pay for it. Kerbing a sidewall while reversing into a tight gap is the single
commonest thing we see on local cars, and a kerbed sidewall is not a cosmetic matter: the cords
inside it are what hold the tyre together and a scuff deep enough to show them is a tyre that
needs replacing rather than watching.
The alignment goes the same way. A kerb hard enough to mark an alloy is usually hard enough to
move the tracking, and once the tracking is out the tyre wears across its width instead of evenly.
People replace a worn tyre, do not check why it wore, and replace the next one early too.
Which is why on anything that has been kerbed we would rather look at the geometry than just
sell a tyre. The tyre is the symptom.
Before you come down
Put your registration in above. It gives us your sizes so the tyres are
here rather than on order while you sit in reception.
Check all four, not just the bad one. Tyres age as well as wear, and a set
bought together tends to need replacing together.
Mention any kerb strike. It changes whether this is a tyre job or an
alignment job, and the alignment is what stops you buying another tyre early.
Look at the inner edges. Wear you cannot see from outside the car is the
wear that tells you the geometry is out.
We will tell you if a tyre has life left in it. Selling four when you needed two is the
quickest way to never see somebody again in a suburb this size.
Mechanical
Tyre Fitting: what’s involved
Your tyres are the only part of the car in contact with the road, so their condition directly affects braking, steering and grip in the wet. The legal minimum tread depth in the UK is 1.6mm across the central three-quarters of the tread, all the way round. Wet-weather grip falls off noticeably well before that, so many drivers change tyres at around 3mm.
The size code on the sidewall, such as 205/55 R16 91V, tells you the width in millimetres, the sidewall height as a percentage of width, radial construction, the rim diameter in inches, the load index and the speed rating. A four-digit date code shows the week and year of manufacture. Getting the right size, load and speed rating matters for safety and for your insurance.
From £20 per tyreWritten quote first
30–60 minutesTypical time in the workshop
3 monthsWorkmanship warranty
Signs you need new tyres
Tread close to the limit
Tread wear indicators are small raised bars in the main grooves. When the tread is level with them, the tyre is at or near 1.6mm and needs replacing.
Uneven wear
Wear on one edge usually points to wheel alignment problems, while wear on both edges or down the centre suggests the tyre has been run under- or over-inflated.
Cuts, bulges or cracks
A bulge in the sidewall means internal damage, often from a pothole or kerb, and the tyre can fail without warning. Deep cuts and cracking also mean replacement.
Tyre pressure warning light
A TPMS light means one or more tyres has lost pressure or a sensor has a fault. It should be checked promptly, and a lit TPMS light is an MOT fail on cars first used from 2012.
Slow puncture
A tyre that needs air every week or two may have a nail, a corroded rim seal or a leaking valve. Many tread punctures can be repaired, sidewall damage can't.
Vibration at speed
A shake through the steering wheel at motorway speeds often means a wheel is out of balance, has lost a weight, or a tyre has internal damage.
Old tyres
Rubber hardens with age even if the tread looks good. Tyres showing cracking or that are many years old are worth inspecting, particularly on low-mileage cars.
When should tyres be replaced?
Replace tyres before they reach 1.6mm, and ideally around 3mm if you want to keep good wet grip. Any tyre with a bulge, a deep cut, exposed cords or sidewall damage should be replaced straight away, whatever the tread depth. Check tread and pressures at least once a month and before long journeys. Where possible, replace tyres in pairs on the same axle so grip and handling stay balanced side to side.
Legal minimum: 1.6mm across the central three-quarters of the tread, all the way round
Recommended replacement: around 3mm for better wet grip
Immediately for bulges, cuts, exposed cords or sidewall damage
Check pressures at least monthly and before long trips
Replace in pairs on the same axle where possible
How we fit tyres
Check-in and tyre checkWe check the size, load index and speed rating your car needs, the condition of the other tyres, and whether it has run-flats or TPMS sensors.
Remove the wheelThe wheel comes off the car, including locking wheel nuts using your key, and the old tyre is deflated.
Demount the old tyreThe tyre is removed on a tyre machine, taking care around TPMS sensors and with alloy wheels, so rims aren't marked.
Inspect the rim and valveWe check the rim for cracks, buckles and corrosion on the bead seat, and fit a new valve, or a TPMS service kit where sensors are fitted.
Fit and inflateThe new tyre is mounted in the correct direction or orientation for directional and asymmetric tyres, seated on the bead and inflated.
BalanceEach wheel is balanced on a wheel balancer and weights are fitted to remove vibration at speed.
Refit and torqueThe wheel is refitted and the nuts or bolts tightened with a torque wrench to the manufacturer's figure, then pressures are set to the placard.
TPMS and handoverWe reset or relearn the TPMS where required and check for warnings. If the old tyres showed alignment wear, we tell you so it can be checked.
Tyres we fit
We supply tyres to the size, load index and speed rating your car needs, including run-flat and XL reinforced tyres where specified. We can offer choices across premium and mid-range brands to suit your budget and driving, and we will explain the differences honestly. If your car has manufacturer-approved tyres, marked on the sidewall with a code such as a star for BMW or MO for Mercedes, we can source those too.
Premium and mid-range tyres in your correct size
Correct load index and speed rating, including XL and run-flat
New rubber valves, or TPMS service kits for sensor valves
Balance weights matched to steel or alloy wheels
Manufacturer-approved tyres on request
How long it takes
30–60 minutes
Fitting and balancing one or two tyres usually takes 30–45 minutes, and a full set up to about an hour. Run-flats and cars with TPMS can take a little longer. If your size needs ordering, we will tell you the date when you book.
What’s included
Removal and fitting of the tyre
New valve, or TPMS service kit where needed
Wheel balancing
Wheel nuts torqued to specification
Pressures set to the manufacturer's figures
Environmentally responsible disposal of the old tyre
Finding us
We are on London Road, which is the point
There is no journey to describe. We are at Unit 1 Soho Mills on London Road, which is the road
you are already on — a couple of minutes from the station, the parade and the level
crossing, and inside the SM6 postcode rather than a drive away from it.
That changes how you can use us, and it is worth saying plainly:
You can walk in. If something is making a noise, bring it down and we will
look at it rather than booking you in for a week on Thursday to hear a description of it.
You can leave the car and walk home. Most of Hackbridge is ten minutes on
foot from the yard, which removes the whole business of arranging a lift or waiting in a
reception.
You can get to the station from us. If the car has to stay in, you are a few
minutes from the platform rather than stranded.
We can look at it before quoting. Where a job needs the car on a ramp to
price honestly, being local means that is a short detour rather than a second trip across
town.
Being the workshop in the place rather than the workshop near it is most of why people use us.
It is also why we would rather tell you something is not worth repairing than take the work —
we are going to see you in the Co-op.
Tyre Fitting in Hackbridge: your questions answered
I kerbed it reversing into a space. Is the tyre still safe?
If the scuff is deep enough to show the cords in the sidewall, no. A sidewall is not repairable and the cords are what hold the tyre together. Bring it down and we will look.
Do I need the alignment doing as well?
If the kerb was hard enough to mark the wheel, usually yes. Tracking knocked out by a kerb wears the new tyre unevenly and you end up buying another one early.
Can you do all four while I wait?
Usually, if we know you are coming. Put your registration in above so we have the right sizes on the shelf rather than ordering them while you sit there.
Where exactly are you in Hackbridge?
Unit 1 Soho Mills, London Road, SM6 7HN — a couple of minutes from Hackbridge station and the parade. There is room to leave a car with us.
Can I just turn up?
For a look at something, yes. For work that needs a ramp and a slot, call or put your registration into the box on this page first so we can give you a time rather than keep you waiting.
Instant quote
Price your tyre fitting now
Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.
Free, about 30 seconds, no sign-up
Parts, labour and VAT included
3-month workmanship warranty
Collection from Hackbridge can be arranged
“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google