How we handle brake repair at Hackbridge
Every brake job here starts with numbers. Disc thickness is measured with a micrometer at several points around the face, taken from inside the wear lip, and compared against the minimum figure cast or stamped into the disc itself. Pad material is measured rather than eyeballed. Where the complaint is a judder, a dial gauge goes on the hub and runout is checked before anything is condemned, because rust or dirt behind the disc produces exactly the same symptom as a worn one. Fluid is tested for moisture content and the reading is written on your sheet alongside the level at which it should be renewed.
Fitting is where brakes are made or ruined. Hub faces are cleaned back to bare metal so the new disc sits flat, because a few hundredths of a millimetre of rust behind a disc is enough to bring the judder back within a few thousand miles. Slide pins are cleaned and go back with a rubber-compatible brake grease rather than copper grease, which attacks the pin seals and boots. Anti-rattle hardware is renewed where the kit supplies it. Carrier bolts and wheel fixings are tightened with a torque wrench rather than a rattle gun, and cars with electrically operated rear brakes are put into service mode and recalibrated afterwards.
We do not machine discs that are already close to their minimum thickness, and we do not fit new pads onto a disc that has fallen below it, because a pad cannot do its job against a surface that can no longer carry the heat. We do not top brake fluid up to disguise a leak. We do not sell four corners when two need doing. The quote follows the inspection and is priced on the discs, pads, sensors and hardware your car actually takes, and if a calliper is seized once the wheel is off, you are called before another penny is spent.

