How we handle DPF cleaning at Hackbridge
The differential pressure sensor is where we start, because it is both the instrument and, surprisingly often, the fault. Across a healthy filter the pressure sits very low at idle and climbs predictably as the engine is loaded. The pair of small pipes carrying that pressure to the sensor run hot and can soot up solid or split at the union, and when they do the sensor reports an easy exhaust to an ECU that then never asks for a regeneration. The filter fills in silence until limp mode arrives. We check and clear those pipes as routine rather than condemning the sensor on a code.
Before any forced regeneration we look at the engine oil. Repeated abandoned regenerations put unburnt diesel down the bores and into the sump, and running a deliberate high-temperature burn on an engine already carrying diluted oil is asking for trouble, so that oil gets changed first. During the regeneration itself, exhaust temperature at the filter is driven up to roughly 600 to 650°C, which is what it takes to burn soot off, and we sit with it, watching temperature and the soot figure falling together, with the car positioned so the heat and the smell have somewhere to go. A regeneration left running unattended is not a service, it is a hope.
There is a point past which we will not start one at all. Above a certain soot load the burn can run away from the filter's ability to shed heat and melt or crack the substrate inside, turning a cleanable filter into a replacement one, so if the data reads above that threshold we stop and explain the alternatives instead. We do not write delete software, fit emulators or gut filters, whoever asks. Cleaning starts from £250, and the quote separates diagnosis, the clean itself and any parts, so you can see what you are paying for.

