Audi SQ5 in for brake and wheel-speed work at KITH Cars Garage & Bodyworks, Hackbridge

ABS Sensor Replacement in Hackbridge, SM6

ABS Sensor Replacement at our own workshop on London Road, Hackbridge. We test before we sell you anything — on cars that only ever do the station run, a flat battery is as often the symptom as the cause.

  • On London Road, SM6 — walk in
  • Mon–Fri 8am–8pm · Sat 8am–5pm
Loading instant quote…

The battery problem in a commuter suburb

Hackbridge is a station town. Zone 4, about 25 minutes to Victoria, Thameslink and Southern, and a great many residents who drive a mile to the station and leave the car standing until the evening. In winter that car is started cold, run for four minutes, and parked.

A four-minute run does not put back what starting takes out, particularly with heated screens, lights and a blower all on. The battery sits slightly flat, and a battery that sits slightly flat sulphates and loses capacity permanently. That is why batteries around here fail at three years rather than five, and why the failure arrives in the first properly cold week rather than gradually.

It also disguises other faults. A small parasitic drain, an alternator that is not quite charging, a dying earth, all of them look exactly like a tired battery on a car that never gets a decent run. Replacing the battery makes the symptom go away for a few weeks and then it comes back, which is why the test matters more than the part.

We check the charging side and the drain before selling anybody a battery, because on this driving pattern the battery is as often the victim as the culprit.

The tests we run before selling you a part

  • Battery state of health, not just voltage. A battery can read 12.5 volts and still be unable to turn the engine on a cold morning.
  • Charging output under load. An alternator that charges at idle and not under load looks exactly like a tired battery.
  • Parasitic drain. Measured properly, with time for the modules to go to sleep. This is where aftermarket alarms and trackers usually show up.
  • Earths and connections. Corroded earth straps cause faults all over a car and cost almost nothing to put right.

On the local driving pattern the battery is as often the victim as the culprit, so replacing it first and testing afterwards is how people end up buying two.

ABS Sensor Replacement: what’s involved

Each wheel has a speed sensor that reads a toothed or magnetic ring turning with the hub or driveshaft. The ABS module constantly compares the four signals. If one wheel slows too quickly under braking, the system releases and reapplies that brake to stop it locking. The same signals feed traction control, stability control and often the speedometer, hill-hold and tyre pressure warning.

Older cars use passive sensors that generate their own signal. Most modern cars use active sensors, which are powered by the ABS module and often read a magnetic encoder built into the wheel bearing seal. Sensors sit right next to the brakes, exposed to heat, water, salt and brake dust, so corrosion, damaged wiring and failed connectors are common. When a signal drops out, the system switches ABS and stability control off and lights the warning. Your normal brakes still work.

From £89Written quote first
45 minutes–2 hoursTypical time in the workshop
3 monthsWorkmanship warranty

Signs of an ABS sensor fault

ABS warning light on

A steady ABS light means the system has switched itself off. Normal braking still works, but the wheels can lock under heavy braking.

Traction and stability lights too

Because they rely on the same wheel speed signals, the traction control or ESP light usually comes on with the ABS light.

Light comes and goes

An intermittent warning, often after bumps, in wet weather or at a certain speed, usually points to damaged wiring, a loose connector or a corroded sensor.

ABS pulsing at low speed

If the pedal pulses and the ABS activates when stopping gently, a sensor may be giving a false reading from a dirty sensor or a cracked reluctor ring.

Speedometer or tyre warning faults

On cars that take road speed or tyre pressure monitoring from the wheel sensors, a faulty sensor can upset the speedometer or set a tyre warning.

Other systems disabled

Hill-hold, cruise control, stop-start and some electric parking brake functions may stop working when a wheel speed signal is missing.

When should it be done?

ABS sensors have no replacement interval. They are replaced when they fail or when their wiring is damaged. Get the car checked as soon as the ABS light comes on, because the car won't stop as well in an emergency on a wet road without ABS and stability control. An ABS warning light that stays on is also an MOT failure. Faults often show up after brake, hub or suspension work, when a sensor or its wiring may have been disturbed.

  • ABS, traction or stability warning light on
  • Intermittent warnings in wet weather or over bumps
  • Warning lights after brake, wheel bearing or suspension work
  • Before an MOT if the ABS light is showing

How we replace an ABS sensor

  1. Check-in and symptomsWe ask when the light appears and whether any work has been done recently, as disturbed wiring after brake or suspension work is common.
  2. Diagnostic scanWe read the ABS module fault codes to identify which wheel is affected and whether the fault is signal, circuit or plausibility related.
  3. Live data and testingWe compare live wheel speed readings on a road test or ramp and test the sensor circuit with a multimeter or oscilloscope to separate sensor, wiring and ring faults.
  4. Inspect the ring and bearingWe check the reluctor ring or magnetic encoder for cracks, corrosion or damage and check the wheel bearing for play, as either can cause a false signal.
  5. Written quoteWe explain the cause and give you a written quote. If the encoder is built into the wheel bearing, we'll explain why the bearing may need replacing.
  6. Replace the sensorWe carefully remove the old sensor, which is often seized in the hub, clean the mounting, and fit the new sensor with its wiring routed and secured correctly.
  7. Clear codes and road testWe clear the fault codes, road test to confirm all four wheel speeds read correctly and the warning lights stay off, and run any calibration the car needs.

Parts we fit

Sensors must match the car exactly. Active and passive types are not interchangeable, and connectors and lengths vary between models and even between axles. We fit OE or OE-equivalent sensors from manufacturers such as Bosch, ATE or Continental. Where the wiring is damaged we repair it properly with sealed connectors, and where the fault is in a reluctor ring or a wheel bearing encoder, we replace that part rather than just the sensor.

  • OE or OE-equivalent ABS wheel speed sensors
  • Reluctor rings where cracked or corroded
  • Wheel bearings with integral magnetic encoders where required
  • Sensor wiring and sealed connector repairs

How long it takes

45 minutes–2 hours

A straightforward sensor swap often takes under an hour. Seized sensors, wiring repairs or a reluctor ring or wheel bearing replacement take longer. Most jobs are completed the same day.

What’s included

  • ABS system fault code scan
  • Wheel speed live data check
  • Sensor circuit and reluctor ring inspection
  • Correct replacement sensor fitted
  • Fault codes cleared
  • Road test to confirm the warning lights stay off

We are on London Road, which is the point

There is no journey to describe. We are at Unit 1 Soho Mills on London Road, which is the road you are already on — a couple of minutes from the station, the parade and the level crossing, and inside the SM6 postcode rather than a drive away from it.

That changes how you can use us, and it is worth saying plainly:

  • You can walk in. If something is making a noise, bring it down and we will look at it rather than booking you in for a week on Thursday to hear a description of it.
  • You can leave the car and walk home. Most of Hackbridge is ten minutes on foot from the yard, which removes the whole business of arranging a lift or waiting in a reception.
  • You can get to the station from us. If the car has to stay in, you are a few minutes from the platform rather than stranded.
  • We can look at it before quoting. Where a job needs the car on a ramp to price honestly, being local means that is a short detour rather than a second trip across town.

Being the workshop in the place rather than the workshop near it is most of why people use us. It is also why we would rather tell you something is not worth repairing than take the work — we are going to see you in the Co-op.

Open in Maps

ABS Sensor Replacement in Hackbridge: your questions answered

My battery keeps going flat. Is it just old?

Maybe, and maybe not. On cars that only do the station run a battery never fully recharges, but a parasitic drain or a weak alternator looks identical. We test the charging and the drain before selling you a battery.

The light is on but the car drives fine.

Still worth reading. A stored fault that has not yet become a symptom is the cheap version of the same problem.

Do you clear codes without fixing anything?

No. Clearing a code without finding what set it is selling you a few quiet days, and it comes back.

Where exactly are you in Hackbridge?

Unit 1 Soho Mills, London Road, SM6 7HN — a couple of minutes from Hackbridge station and the parade. There is room to leave a car with us.

Can I just turn up?

For a look at something, yes. For work that needs a ramp and a slot, call or put your registration into the box on this page first so we can give you a time rather than keep you waiting.

Price your ABS sensor replacement now

Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.

  • Free, about 30 seconds, no sign-up
  • Parts, labour and VAT included
  • 3-month workmanship warranty
  • Collection from Hackbridge can be arranged
“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google

Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Chat on WhatsApp