Ford van in for engine mount and manifold gasket work at KITH Cars Garage & Bodyworks, Hackbridge

Exhaust Repairs for Morden Commuters and Families

Short drives to Morden station and the traffic calming on the St Helier estate are two of the quickest ways to wear out an exhaust. We're around 12 minutes away in Hackbridge, and we inspect the whole system on a ramp before quoting.

  • ~12 min from Morden
  • Mon–Fri 8am–8pm · Sat 8am–5pm
Loading instant quote…

Station runs, traffic calming and a knocking exhaust

For a lot of Morden households, the car's main job is a short hop to the station and a day parked, or a slow circuit of the controlled zones M1 to M4 looking for a space. It's hardly any distance, and that's the problem. The exhaust never fully warms through, so condensation collects in the rear silencer and corrodes it from the inside. The first sign is usually a deeper note or a soft blowing sound from the back of the car.

The long avenues of the St Helier estate add another kind of wear. Traffic calming flexes the car on its suspension, and an exhaust hanging on tired rubber mounts moves with it. Over time it starts to knock against the floor or the rear subframe, and a pipe that has been knocked out of line puts extra strain on the joints until one lets go. Commuters' cars, which spend the day parked and the evening doing short trips, get the worst of both.

So a knocking exhaust on a Morden car isn't always a silencer problem. We check the hangers, brackets and heat shields as carefully as the pipes, because a new section hung on the old rubbers won't last. We also check the joints either side of any knock point, as that's where a cracked flange usually shows up. On the ramp we look at the whole system, from the manifold to the tailpipe, keep anything that's sound and give you a written quote for what isn't.

From Morden Underground station, the route runs along Morden Hall Road past Morden Hall Park, then east on the A239 into Mitcham and down Carshalton Road to Hackbridge, about 4 miles. If you're on the St Helier Avenue side, it's just as quick to head down to the Rose Hill roundabout and follow Wrythe Lane. Collection and delivery can be arranged, and repairs carry our 3-month workmanship warranty.

Exhaust Repairs: what’s involved

An exhaust does more than carry fumes away. The manifold collects gases from the engine, the catalytic converter cleans them, and on diesels the DPF traps soot. Silencers reduce noise, a flexible section absorbs engine movement, and rubber hangers hold everything clear of the body. Lambda sensors before and after the catalyst tell the ECU how well the engine is burning fuel and whether the catalyst is working.

Exhausts live in a harsh place. Short journeys leave acidic condensation sitting inside silencers, road salt attacks the outside, and speed bumps and kerbs knock pipes out of line. A leak changes more than the noise. It can let fumes into the cabin, upset lambda sensor readings and cause an MOT failure. Catalytic converters are also targeted by thieves, particularly on some hybrids, and a stolen cat needs replacing before the car can be driven legally.

From £205Written quote first
1–3 hoursTypical time in the workshop
3 monthsWorkmanship warranty

Signs your exhaust needs attention

Louder engine or blowing noise

A deeper roar or a chuffing noise that rises with engine speed usually means a hole, a failed joint or a split flexi pipe.

Rattling underneath

Loose heat shields, broken clamps or a collapsed internal baffle in a silencer all rattle, often most noticeably at idle or over bumps.

Exhaust hanging low or knocking

Perished rubber hangers or broken brackets let the system drop and knock against the floor or suspension.

Fumes smell in the cabin

A leak near the front of the system can draw fumes into the car. This needs checking promptly because exhaust gas contains carbon monoxide.

Engine light with catalyst or lambda codes

Catalyst efficiency and lambda sensor codes can mean a failing cat, a faulty sensor or an air leak upstream of the sensor that upsets its readings.

Sudden very loud noise on start-up

An exhaust that sounds dramatically louder overnight, especially on a hybrid, may mean the catalytic converter has been cut out.

Visible rust or holes

Heavy scaling, holes in silencer boxes and corroded joints are usually spotted at service or MOT before they start to blow.

When should it be done?

There is no fixed replacement interval for an exhaust. Life depends on the materials, the car and how it is used, with lots of short trips shortening it most. Get the system checked as soon as the note changes, something is rattling or hanging low, or you smell fumes. A leak or insecure exhaust is an MOT failure, so it makes sense to deal with it before the test rather than after.

  • Any change in exhaust noise, blowing or rattling
  • Fumes smell inside the car
  • Catalyst or lambda sensor fault codes
  • Advisories for corrosion or insecure mountings at MOT or service
  • After suspected catalytic converter theft

How we repair an exhaust

  1. Check-in and listenWe ask what you have noticed and listen to the car running, as the type of noise often points to the area of the leak.
  2. Lift and inspectWith the car on a ramp we inspect the whole system, from the manifold back, including joints, flexi pipe, silencers, hangers, heat shields and sensors.
  3. Check codes where relevantIf there are catalyst or lambda codes we scan the car and check sensor data, so we don't replace a cat when the cause is a sensor or a leak.
  4. Written quoteWe explain which sections need replacing and why, and give you a written quote. Where a section is sound, we keep it.
  5. Remove the old sectionsWe remove the failed parts, cutting seized fixings where necessary, and inspect the joints and brackets we are connecting to.
  6. Fit new partsWe fit the new sections with new gaskets, clamps and hangers, aligning the system so it sits clear of the body and doesn't knock.
  7. Leak test and road testWe run the engine and check every joint for leaks, clear any related codes and road test the car to check for noise and knocks.

Parts we fit

We fit OE or OE-equivalent exhaust parts made to fit the vehicle properly, such as Bosal, Walker or BM Catalysts, rather than universal sections that need bodging to fit. Replacement catalytic converters are type-approved for the vehicle so it meets its emissions standard. We always renew gaskets, clamps and rubber hangers when fitting a new section, as reusing old ones is a common cause of leaks.

  • Vehicle-specific front pipes, centre sections and rear silencers
  • Flexi pipes and manifold gaskets
  • Type-approved catalytic converters
  • Lambda (oxygen) sensors
  • New clamps, gaskets and rubber hangers

How long it takes

1–3 hours

A rear silencer or flexi pipe is often done in an hour or two. Catalytic converters, manifolds and badly seized systems take longer, and some parts may need ordering in.

What’s included

  • Full inspection of the exhaust system on a ramp
  • Written quote before any work starts
  • Removal of failed sections
  • New gaskets, clamps and hangers as required
  • Leak check with the engine running
  • Road test

From Morden to our Hackbridge workshop

From Morden station take Morden Hall Road to the Morden Hall roundabout, then follow Morden Road (A239) east past Morden Hall Park into Mitcham. At the Cricket Green stay on the A239 into Cranmer Road, then join Carshalton Road (A237) heading south over the railway by Mitcham Junction; past Beddington Corner it becomes London Road into Hackbridge, where Soho Mills is near Hackbridge station.

Follow Morden Hall Road and the A239 past Morden Hall Park into Mitcham, then Carshalton Road (A237) south to Hackbridge, around 12 minutes. If something has broken and is dragging, we can collect the car.

Directions from Morden

About Morden

Morden is a suburban town at the southern end of the Northern line, and grew rapidly after Morden Underground station opened in 1926, with its population rising from about 1,300 in 1921 to over 12,000 by 1931. Much of the housing is 1920s and 1930s semis and terraces, including a large part of the London County Council's St Helier estate, laid out along wide avenues and cul-de-sacs. The town centre is compact and dominated by the station and the Crown House civic tower, with generous parks on either side. It is a family and commuter suburb where most journeys are by car or bus to the station, so the few main roads carry most of the traffic.

Places nearby: Morden Hall Park, Morden Underground station, Baitul Futuh Mosque, St Lawrence Church, Morden Park, Morden Park House

Postcodes: SM4 · London Borough of Merton

More about KITH for Morden drivers

Exhaust Repairs in Morden: your questions answered

Why does my exhaust only knock when I go over speed humps?

Usually a hanger has perished or stretched, letting the pipe drop enough to touch the floor or subframe as the car moves. Sometimes it's a loose heat shield. It's normally a quick repair once we've found the point of contact.

My car only does short trips to Morden station. Will the exhaust last?

Short trips shorten exhaust life because condensation sits inside the silencers. It won't fail overnight, but expect the rear box to go sooner than on a car doing longer runs. An occasional longer drive helps dry the system out.

Can I drop the car off and still get to work?

Yes. Hackbridge station is close to us, with Thameslink trains that call at Mitcham Junction, where you can pick up the tram towards Wimbledon. Alternatively, we can collect the car from Morden so you can commute as usual.

Do I need a whole new exhaust?

Usually not. Exhausts are made in sections, and we only replace the parts that have failed. If a neighbouring section is badly corroded and likely to break when disturbed, we will tell you and let you decide.

Can you weld my exhaust instead?

Sometimes, where the pipe around a small hole or split is still sound. On thin, corroded silencers a weld often won't last, so a new section is better value. We'll give you an honest view once we see it.

Will an exhaust leak fail the MOT?

Yes. A leaking exhaust, an insecure system or a missing catalytic converter where one was fitted as standard is an MOT failure. Excessive noise and failing the emissions test are also reasons for failure.

My catalytic converter was stolen. What now?

Don't drive the car far. It will be very loud and may run poorly, and it isn't legal on the road without its cat. Report the theft to the police and your insurer, then we can quote for a type-approved replacement.

Do you replace DPFs too?

Yes, where a diesel particulate filter is damaged or too ash-loaded to clean we can quote for replacement. If it is simply blocked with soot, cleaning may be the better option, which we cover under our DPF cleaning service.

Price your exhaust repair now

Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.

  • Free, about 30 seconds, no sign-up
  • Parts, labour and VAT included
  • 3-month workmanship warranty
  • Collection from Morden can be arranged
“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google

Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Chat on WhatsApp