When a Purley car's cambelt is due on age, not miles
A good share of the cars we see from Purley are low-mileage models that spend much of the week on a driveway in Riddlesdown or Woodcote, heading out for local shopping, trips to Riddlesdown Common or the occasional run up Purley Way. Owners are often surprised that a car with 25,000 miles on the clock needs a cambelt, but every manufacturer sets an age limit as well, commonly somewhere between four and ten years depending on the engine.
Rubber ages with heat cycles and time. A belt that has sat still for months can take a set, and the tensioner and idler bearings can dry out. When a car like that is finally used for a longer trip, such as down the A23 Brighton Road towards the M25, it is not unusual for an aged belt or bearing to give up. There is rarely any warning, and most modern engines are interference designs, so the valves are at risk. We would much rather change a belt a little early than see a car recovered from the Brighton Road.
Purley's hills add a little extra load too. The steep, winding roads climbing out of the valley ask a lot of the cooling system, and on engines where the belt drives the water pump, a pump that has been sitting unused can start to leak once it is worked hard. We replace a belt-driven pump with the belt as standard and check the rest of the belt drive for oil and coolant contamination.
If you are managing a car for a relative and are not sure of its history, bring whatever paperwork you have and we will piece it together. Without proof of a change, we recommend doing it. Collection and delivery can be arranged if driving through Purley Cross is a chore, and the work is covered by our 3-month workmanship warranty.

