Bonnet Repair

Bonnet is pressed steel, and aluminium on a lot of newer and premium cars, and that decides most of what a repair costs. Here is the rate card, what we actually do to it, and when replacing is the better answer.

  • Hackbridge SM6 7HN
  • Any insurer · your choice of repairer
Loading instant quote…

What bonnet damage costs

Everything below is inclusive of VAT, for an ordinary five-seater, and includes blending the paint into both front wings and the top edge of the front bumper. Blending is not an extra on our rate card.

DamageWhat that meansPrice inc VAT
Light scuff or scratchSmaller than your phone, paint not broken through£140 – £210
Scuff or scratchBigger than your phone, or through to primer£180 – £270
Dent or damaged panelPushed in, creased, cracked or split£260 – £540

An SUV or estate runs £310 to £590 on the heaviest of those, and a van £380 to £660. Every band runs upward from the rate card rather than either side of it: the card figure is the floor, and what we cannot know before seeing the car is how much more the job is, never how much less.

What bonnet actually is

Bonnet is pressed steel, and aluminium on a lot of newer and premium cars. It unbolts at the hinges and goes onto a stand, which gives a flat horizontal surface to work and to paint.

Behind it sits the sound insulation pad, the catch and release mechanism, and the washer pipework. All of that comes out or gets protected before any paint goes near the car, and anything electrical is tested again before you collect it.

The bonnet is a large flat horizontal panel in full daylight, which makes it the second hardest panel on the car to match after the roof. Metallics show any difference in how the flake has laid down, and they show it from across a car park rather than up close. A bonnet is painted complete and blended into both wings for exactly that reason.

How bonnets get damaged

Four causes account for most of what comes through the door:

  • Stone chips along the leading edge, which is the most common bonnet job by far.
  • Falling branches and garage doors, which dent the flat centre.
  • Being leant on or sat on, which creases it in a way that is hard to pull out.
  • Corrosion along the front edge where chips have been left to work.

The thing worth checking. Whether it is steel or aluminium. Aluminium needs different filler, different preparation and isolation from steel tooling, and getting that wrong causes corrosion that appears months later as blistering under the paint.

Repair or replace

Bonnets are available cheaply for common cars and replacement is often sensible on heavy damage. On anything where the panel is aluminium or the colour is difficult, repairing the original is usually the better outcome.

How long it takes. Two days for most work. A bonnet with a lot of chips is often better refinished complete than chased chip by chip, and that is still two days.

Stone chips, and when to stop ignoring them

Every bonnet picks up chips along its leading edge. They are cosmetic right up until the moment they are not: once you can see brown staining in the bottom of a chip, the steel underneath has started to corrode and it spreads sideways under the paint film where you cannot see it.

Caught early, chips are filled, flatted level and the area refinished. Left for a couple of winters, the same bonnet needs the leading edge cut back to clean metal first, and that is a materially bigger job. If you can see brown, it is worth doing this year rather than next.

Worth doing while the bonnet is off

A bonnet that has been refinished has a brand new paint surface on the one panel of the car that takes the most stone damage, and it will start collecting chips again from the first motorway run. If you are having the work done anyway, a clear protection film along the leading edge is worth asking about, because applying it to fresh paint is both easier and more effective than applying it over a surface that already has chips in it.

The other thing worth doing with the bonnet off is the catch and the hinges. They are accessible for about an hour a decade, and a bonnet that has been in an impact frequently sits a fraction high on one side afterwards because the hinge has moved rather than the panel. Setting the gaps properly on refit is part of the job for us; it is also the thing most often skipped elsewhere, because it takes time and does not show in a photograph.

Price your bonnet now

Put your registration in and we will price it. Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Your questions answered

Can you repair bonnet without painting it?

Only where the damage is in the lacquer alone, and we will tell you if yours is one of those rather than selling you a respray. Once it is through the colour, refinishing is the only repair that lasts. On dents there is no paint-free option at all — we do not do paintless dent removal, so the panel is straightened and then painted.

Will the colour match?

It is mixed to the paint code on your car, then sprayed into both front wings and the top edge of the front bumper rather than stopped at the shut line. Two cars with the same code are rarely identical after a few years of sun, and blending is what makes the difference invisible instead of nearly right.

Is it guaranteed?

One year on paint, three months on mechanical work, in writing.

Should I claim on insurance?

At £140 to £540 it is worth checking your excess first. Plenty of single-panel jobs cost less than the excess, and paying directly avoids declaring a claim for five years. We will price it either way and we are not on any insurer’s panel, so we have no reason to push you one way.

Do you need to see the car first?

Not to give you a price band — put your registration in the box above. We confirm the exact figure when we see it, because how far the damage goes is the one thing photographs do not show reliably.

Chat on WhatsApp